Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Log In

A valid email is required.
Password is required.
Site Notices
6/21/2017 8:25:40 PM
Posted: 4/25/2001 5:59:43 PM EDT
I just got a CAV COMP from Brownell's. It comes with a 5/64 pin and small hole. this is a quote: "For installation on a post-ban rifle. With a hand drill, use the hole in the bottom of the comp to guide a 5/64th drill bit no more than 1/16th of an inch into the barrel. Drive the enclosed roll pin completely into the hole to permanently affix the comp onto the barrel." Is this enough? or do I need to weld or hi-temp silver solder?
Link Posted: 4/26/2001 5:46:57 PM EDT
If your barrel is threaded you have to weld it or use a high temp silver solder ( with a melting point of at least 1100 degrees F)
Link Posted: 4/27/2001 12:56:24 PM EDT
Top Top