Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Log In

A valid email is required.
Password is required.
Site Notices
6/21/2017 8:25:40 PM
Posted: 3/24/2001 7:02:48 AM EDT
What is the accepted methods of legally attaching a barrel extension. I have a 11.5" pre-ban(threaded) barrel and wish to put a 5.5" flash suppressor thereby making it a legal 16". I have heard silver solder is acceptable but don't really know.
Link Posted: 3/24/2001 7:18:06 AM EDT
Ken, Any of the weld/pin combination type methods are acceptable. It just has to be what they consider "permanent", or can't be removed with a tool without rendering the weapon usless type. None of the glue-on/epoxy/locktite type methods are accepted by the BATF. You can do a search on the web for BATF rulings and this is covered. You can probably find this covered somewhere in the older postings on this board even. Good luck. DK
Link Posted: 3/24/2001 7:53:58 AM EDT
Ken,go to the industry formums and ask KURT'S KUSTOM he can do it for at a reasonable price and you will never know that its welded on.I have never personnely had him do any work,but people rave about his work on this formum.I'm sure someone esle will tell you about his work. Rich
Link Posted: 3/24/2001 7:02:54 PM EDT
[Last Edit: 3/25/2001 7:18:17 AM EDT by Ken]
I can do it myself once I know what"approved" method to use. I am a gunsmith albeit a correspondence course. I worked in a shop for 18 months and should probably know the answer to this question already. Guess I should call the nearest ATF office....I just don't want to.
Link Posted: 3/24/2001 7:30:02 PM EDT
The methods I've seen as approved are: 1) blind pin and weld over the pin 2) high temp silver solder over >50% of the circumference 3) four or more equidistant spot welds around the circumference. The most common method I've seen is blind pin and weld the pin in place.
Link Posted: 3/24/2001 7:52:49 PM EDT
I had planned on sweating silver solder into the threads. ts-8,000 psi/mp-460 degrees F. I thought that would look best. Think it'll fly?
Link Posted: 3/25/2001 2:36:53 AM EDT
As I understand it, the silver solder has to be 1100f - 480f wouldn't cut it.
Link Posted: 3/25/2001 4:26:04 AM EDT
Ah...thats the rub. Thanks circuits. I knew I read something somewhere's....couldn't recall.
Top Top