Quote History Quoted:
Looks like its missing a power supply
View Quote
That's on order.
I'm just trying to figure out how to configure a backup port now.
We just installed a 100meg MPLS on a fiber ring. The handoff is 2 fiber cables, one for the north loop and the other for the south loop. Both terminate at the same data center, but only 1 is meant to be active at any one time. So if the fiber on the north loop gets cut, the router should see a dead link and switch to the south loop.
I think I got it, but I'm waiting on Cisco to confirm. The below config should switch over to Gi0/0/1 after 30 seconds of no signal on 0/0/0.
interface GigabitEthernet0/0/0
description 100MB MPLS North Loop
backup delay 30 never
backup interface GigabitEthernet0/0/1
ip address X.X.X.X 255.255.255.252
media-type sfp
negotiation auto
!
interface GigabitEthernet0/0/1
description 100MB MPLS backup South Loop
ip address X.X.X.X 255.255.255.252
media-type sfp
negotiation auto