On Sunday I reprogrammed my ft-7800 using CHIRP.
I overwrote several previously programmed locations. All new entries are repeaters with tone.
Listening works good. And on Sunday I transmitted fine on one of the new memory locations.
On Tuesday evening I powered it up and choose a different one of the new channels for a local net.
During check in I keyed up and the radio locked on TX. I had to power cycle to clear it.
I tried again on the same location and it again locked. I powered down and had to call it a night.
Last night, well really 2 am this morning, I keyed up on a different memory location and all was fine.
Went back to the problem location and keying up again locked it.
What am I missing when I look at the configuration that I haven't seen yet?
I can provide details of power levels, memory locations, etc later if needed.
I'm hoping this is a known operator error for CHIRP and the FT-7800.
thx.