Changing the FIRING PIN on a PF9. HALP!!!!
The tutorials I found online SUCK.
I need to remove the extractor spring Allen screw to remove the FP, correct?
Well if so, I've done that and the FP will not come out? WTF?
Thanks!
www.ktog.org is a wealth of information on all Kel-Tec products. You will find your answer there.
I had the same problem when I had to remove my firing pin. It was tough for me to get out. I had to wrap a towel around the backside so I didn't damage it, then I banged it good against a wood block. Then I still had to use needle nose pliers to pull the sucker out. Turns out there was a TON of brass shavings stuck in there and it was causing light strikes. I cleaned out the firing pin channel and lightly lubed the pin and spring and reassembled. Works great now.
